2-4 Advanced BIOS Features
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
Advanced BIOS Features
!
Г
• Hard Disk Boot Priority
[Press Enter]
Item Help :|
i First Boot Device
[Floppy
1
1 Menu Level>
1
Second Bool Device
[Hard Disk]
' Third Boot Device
[CDROM]
Password Check
|
Setup]
- HDD S.M.A.R.T. Capability [Disabled]
|
CPU Hvper-Threading
[ Enabled |
Limit CPU ID Max. to ЭРЙ
IDisabled]
1 No-Execute Memory Protect
l№,,sl
|Enabled]
CPU Enhanced Halt (C1E)"
1
®'
[Enabled |
CPl
:
Thermal Monitor 2<TM2>
,Na
»
fEnabled|
; CPU El ST Function
,№
»
e
'
|
Enabled |
Virtualization Technology '
No,r
'
[Enabled |
Init Display First
i PCI |
On Chip Frame Buffer Sue
|8MB|
T4-»«-: Move Enter: Select
+/-/PU/PD: Value F10: Save
ESC:
1
Exit F1: General Help ||
F5: Previous Values
F6: Fail-Safe Defaults
F7: Optimized Defaults
^ Hard Disk Boot Priority
Specifies the sequence of loading the operating system from the installed hard drives. Use the up
or down arrow key to select a hard drive, then press the plus key <+> (or <PageUp>) or the minus
key <-> (or <PageDown>) to move it up or down on the list. Press <Esc> to exit this menu when
finished.
First/Second/Third Boot Device
Specifies the boot order from the available devices. Use the up or down arrow key to select a
device and press <Enter> to accept. Options are: Floppy, LS120, Hard Disk, CDROM, ZIP,
USB-FDD, USB-ZIP, USB-CDROM, USB-HDD, LAN, Disabled.
<y Password Check
Specifies whether a password is required every time the system boots, or only when you enter
BIOS Setup. After configuring this item, set the password(s) under the Set Supervisor/User
Password item in the BIOS Main Menu.
•• Setup A password is only required for entering the BIOS Setup program. (Default)
•• System A password is required for booting the system and for entering the BIOS Setup
program,
o- HDD S.M.A.R.T. Capability
Enables or disables the S.M.A.R.T. (Self Monitoring and Reporting Technology) capability of your
hard drive. This feature allows your system to report read/write errors of the hard drive and to
issue warnings when a third party hardware monitor utility is installed. (Default: Disabled)
o- CPU Hyper-Threading <
No,e
>
Enables or disables Intel® Hyper-Threading Technology. This feature only works for operating
systems that support multi-processors mode. (Default: Enabled)
(Note) This item is present only if you install a CPU that supports this feature. For more information
about Intel CPUs' unique features, please visit Intel's website.
- 37 -
BIOS Setup
To Next Page
Loading...
