10) F_PANEL (Front Panel Jumper)
Please connect the power LED, PC speaker, reset switch and power switch etc. of your chassis
front panel to the F_PANEL connector according to the pin assignment below.
| IDE Hard Disk Active LED
MSG (Message LED/Power/Sleep LED)
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
PW (Power Switch) Open: Normal
Close: Power On/Off
SPEAK (Speaker Connector) Pin 1: Power
Pin 2- Pin
3:
NC
Pin 4: Data(-)
HD (IDE Hard Disk Active LED) Pin 1: LED anode(+)
Pin 2: LED cathode(-)
RES (Reset Switch) Open: Normal
Close: Reset Hardware System
NC
NC
- 25 -
"Hardware Installation
To Next Page
Loading...
