Gigabyte GA-970A-DS3 - Page 23

- 23 -
CPU Frequency(MHz) &
Allows you to manually set the CPU host frequency. The adjustable range is from 200 MHz to 500 MHz.
This option is congurable only when CPU Host Clock Control is set to Manual.
Important It is highly recommended that the CPU frequency be set in accordance with the CPU
specications.
PCIE Clock(MHz) &
Allows you to manually set the PCIe clock frequency. The adjustable range is from 100 MHz to 150
MHz.
Auto sets the PCIe clock frequency to standard 100 MHz. (Default: Auto)
HT Link Width &
Allows you to manually set the width for the HT Link between the CPU and chipset.
Auto BIOS will automatically adjust the HT Link Width. (Default) 
8 bit Sets HT Link Width to 8 bit. 
16 bit Sets HT Link Width to 16 bit. 
HT Link Frequency &
Allows you to manually set the frequency for the HT Link between the CPU and chipset.
Auto BIOS will automatically adjust the HT Link Frequency. (Default) 
x1~x13 Sets HT Link Frequency to x1~x13 (200 MHz~2.6 GHz). 
DRAM E.O.C.P &
Allows you to determine whether to use the preset memory overclocking prole to achieve optimum
overclocking performance. (Default: Disabled)
Set Memory Clock &
Determines whether to manually set the memory clock. Auto lets BIOS automatically set the memory clock
as required. Manual allows the memory clock control item below to be congurable. (Default: Auto)
Memory Clock &
This option is congurable only when Set Memory Clock is set to Manual. The adjustable range is
dependent on the CPU being installed.
DRAM Conguration &
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
DRAMConguration
CPU Host Clock Control [Auto]
x CPU Frequency(MHz) 200
Set Memory Clock [Auto]
x Memory Clock x6.66 1333Mhz
DCTs Mode [Unganged]
DDR3 Timing Items [Auto] SPD Auto
x 1T/2T Command Timing Auto -- --
x CAS# latency Auto 9T 9T
x RAS to CAS R/W Delay Auto 9T 9T
x Row Precharge Time Auto 9T 9T
x Minimum RAS Active Time Auto 24T 24T
x TwTr Command Delay Auto 5T 5T
x Trfc0 for DIMM1, DIMM3 Auto 110ns 110ns
x Trfc1 for DIMM2, DIMM4 Auto -- --
x Write Recovery Time Auto 10T 10T
x Precharge Time Auto 5T 5T
x Row Cycle Time Auto 33T 33T
x RAS to RAS Delay Auto 4T 4T
**
DCTs Drive Strength
**
DCT0 DCT1

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
