Gigabyte GA-970A-DS3 - 2-4 Standard CMOS Features

- 27 -
Date (mm:dd:yy) &
Sets the system date.
Time (hh:mm:ss) &
Sets the system time.
IDE Channel 0, 1 Master/Slave &
IDE HDD Auto-Detection 
Press <Enter> to autodetect the parameters of the SATA device on this channel.
IDE Channel 0, 1 Master/Slave 
Congure your SATA devices by using one of the two methods below:
Auto Lets the BIOS automatically detect SATA devices during the POST. (Default) •
None If no SATA devices are used, set this item to • None so the system will skip the
detection of the device during the POST for faster system startup.
Access Mode Sets the hard drive access mode. Options are: Auto (default), CHS, LBA, Large. 
IDE Channel 2 Master/Slave &
IDE Auto-Detection 
Press <Enter> to autodetect the parameters of the SATA device on this channel.
Extended IDE Drive 
Congure your SATA devices by using one of the two methods below:
Auto Lets the BIOS automatically detect SATA devices during the POST. (Default) •
None If no SATA devices are used, set this item to • None so the system will skip the
detection of the device during the POST for faster system startup.
Access Mode Sets the hard drive access mode. Options are: Auto (default), Large. 
Capacity Approximate capacity of the currently installed hard drive. 
Halt On &
Allows you to determine whether the system will stop for an error during the POST.
Options are: "All Errors," "No Errors," "All, But Keyboard". (Default)
Memory &
These elds are read-only and are determined by the BIOS POST.
2-4 Standard CMOS Features
CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
Standard CMOS Features
Date (mm:dd:yy) Wed, Jan 4 2012
Time (hh:mm:ss) 22:31:24

IDE Channel 0 Master [None]

IDE Channel 0 Slave [None]

IDE Channel 1 Master [None]

IDE Channel 1 Slave [None]

IDE Channel 2 Master [None]

IDE Channel 2 Slave [None]
Halt On [All, But Keyboard]
Base Memory 640K
Extended Memory 766M

: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level
