Gigabyte GA-970A-UD3P - Chapter 3 Configuring SATA Hard Drive(s)

- 49 -

 
 
 
RAID 0 RAID 1 RAID 5 RAID 10
Minimum
Number of Hard
Drives
 2  
Array Capacity Number of hard

smallest drive

drive


the smallest drive


smallest drive
Fault Tolerance No Yes Yes Yes
RAID Levels

A. 
B. 
C. 

D. Install the SATA RAID/AHCI driver and operating system

Before you begin
• 

• 
• Motherboard driver disk.
• 
• 
• 
 
A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available SATA
port on the motherboard. Then connect the power connector from your power supply to the hard drive.