Gigabyte GA-990FXA-UD5 R5 - Page 26

Hardware Installation
- 26 -
7) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors, Controlled by AMD SB950 South Bridge)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The AMD South Bridge supports
RAID0,RAID1,RAID5,RAID10,andJBOD.RefertoChapter5,"ConguringSATAHardDrive(s),"for
instructionsonconguringaRAIDarray.
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Peripherals\SB SATA
Conguration,"formoreinformation.
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
1
1
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
7
7
0
1
2
3
4
5
SATA3
8) GSATA3 6/7 (SATA 6Gb/s Connectors, Controlled by Marvell
®
88SE9172 Chip)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device. The Marvell
®
chip supports RAID 0 and RAID 1.
RefertoChapter5,"ConguringSATAHardDrive(s),"forinstructionsonconguringaRAIDarray.
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
DEBUG
PORT
G.QBOFM
1
1
7
7
7
6
GSATA3