Gigabyte GA-990FXA-UD5 - 5-1-1 Configuring RAID Set in RAID BIOS

- 73 -
Appendix
C.ConguringRAIDsetinRAIDBIOS
EntertheRAIDBIOSsetuputilitytocongureaRAIDarray.Skipthisstepandproceedwiththeinstallationof
Windowsoperatingsystemforanon-RAIDconguration.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message which
says"Press <Ctrl-F>toenterRAIDOption ROMUtility" (Figure2).Press <Ctrl>+ <F>to entertheRAID
BIOS setup utility.
Step 2:
Main Menu
ThisistherstoptionscreenwhenyouentertheBIOSRAIDSetuputility.(Figure3).
To view the disk drives assigned to arrays, press <1> to enter the View Drive Assignments window.
To create an array, press <2> to enter the LDView/LDDeneMenu window.
To delete an array, press <3> to enter the Delete LD Menu window.
To view controller settings, press <4> to enter the ControllerConguration window.
Figure 3
RAID Option ROM Version 3.3.1540.11
(c) 2011 Advanced Micro Devices, Inc. All rights reserved.
No Array is dened..
Press <Ctrl-F> to enter RAID Option ROM Utility...
Figure 2
View Drive Assignments........................... [ 1 ]
LD View/ LD Dene Menu...................... [ 2 ]
Delete LD Menu....................................... [ 3 ]
Controller Conguration............................ [ 4 ]
Option ROM Utility (c) 2011 Advanced Micro Devices, Inc.
Press 1..4 to Select Option [ESC] Exit
[ Keys Available ]
[ Main Menu ]