BIOS Configuration
4-11
• Boot From LAN First
The default value is Enabled.
Auto Enable Boot From LAN First Function
Enabled Enable Boot From LAN First Function
Disabled Disable Boot From LAN First Function
+You can set “Auto” or “Enabled” to boot from LAN first.
• Boot Sequence
This category determines which drive computer searches first for the
disk operating system (i.e., DOS). Default value is A, C, SCSI.
X1, X2, X3 System will first search for X1 disk drive then X2 disk
drive and then X3 disk drive.
• Swap Floppy Drive
The default value is Disabled.
Enabled Floppy A & B will be swapped under DOS
Disabled Floppy A & B will be normal definition
• VGA Boot From
The default value is AGP.
AGP VGA Boot From AGP
PCI VGA Boot From PCI
• Boot Up Floppy Seek
During POST, BIOS will determine the floppy disk drive installed is 40 or
80 tracks. 360 K type is 40 tracks 720 K, 1.2 M and 1.44 M are all 80
tracks. The default value is Enabled.
Enabled BIOS searches for floppy disk drive to determine it is 40 or
80 tracks. Note that BIOS can not tell from 720 K, 1.2 M or
1.44 M drive type as they are all 80 tracks
Disabled
To Next Page
Loading...
