Gigabyte GA-BX2000 - Page 23

BIOS Configuration
4-23
Figure 4.6: PCI Slot Configuration
R This item will show up when “Used MEM base addr” has been set.
• PNP OS Installed
The default value is No.
Yes Enable PNP OS Installed function.
No Disable PNP OS Installed function.
• Resources Controlled by
The default value is Manual.
Manual User can set the PnP resource (I/O Address, IRQ & DMA
channels) used by legacy ISA DEVICE.
Auto BIOS automatically use these PnP rescuers.
• Reset Configuration Data
The default value is Disabled.
Disabled Disable this function.
Enabled Enable clear PnP information in ESCD.
• IRQ (3,4,5,7,9,10,11,12,14,15), DMA(0,1,3,5,6,7) assigned to
The default value is "Legacy ISA" or "PCI/ISA PnP".
Legacy ISA The resource is used by Legacy ISA device.
PCI/ISA
PnP
The resource is used by PCI/ISA PnP device (PCI or
ISA).
• Used MEM base addr.
The default value is N/A.
N/A Disable the MEM. block using.
C800 ~ DC00 Select the MEM. block starting address.