Do you have a question about the Gigabyte GA-F2A78M-D3H and is the answer not in the manual?
Memory voltage | 1.5 V |
---|---|
Memory channels | Dual-channel |
Memory slots type | DIMM |
Number of memory slots | 4 |
Supported memory types | DDR3-SDRAM |
Maximum internal memory | 64 GB |
Supported memory clock speeds | 1333, 1600, 1866, 2133, 2400 MHz |
Processor socket | Socket FM2+ |
Processor manufacturer | AMD |
Compatible processor series | AMD A |
Maximum number of SMP processors | 1 |
USB 2.0 connectors | 2 |
S/PDIF out connector | Yes |
Number of SATA III connectors | 6 |
Number of Parallel ATA connectors | 0 |
RAID levels | 0, 1, 10 |
Supported storage drive interfaces | SATA III |
USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
Ethernet interface type | Gigabit Ethernet |
Audio chip | Realtek ALC887 |
Component for | PC |
Power source type | ATX |
Motherboard chipset | AMD A78 |
Audio output channels | 7.1 channels |
Motherboard form factor | micro ATX |
Windows operating systems supported | Windows 7 Home Basic, Windows 7 Home Basic x64, Windows 7 Home Premium, Windows 7 Home Premium x64, Windows 7 Professional, Windows 7 Professional x64, Windows 7 Starter, Windows 7 Starter x64, Windows 7 Ultimate, Windows 7 Ultimate x64, Windows 8, Windows 8 Enterprise, Windows 8 Enterprise x64, Windows 8 Pro, Windows 8 Pro x64, Windows 8 x64, Windows 8.1, Windows 8.1 Enterprise, Windows 8.1 Enterprise x64, Windows 8.1 Pro, Windows 8.1 Pro x64, Windows 8.1 x64, Windows XP Home, Windows XP Professional |
Maximum resolution | 4096 x 2160 pixels |
Maximum graphics card memory | 2048 MB |
Parallel processing technology support | - |
BIOS type | EFI AMI |
ACPI version | 2.0a |
Bundled software | Norton Internet Security (OEM) |
Width | 244 mm |
---|
Step-by-step instructions for correctly installing the APU and its cooler.
Guidance on installing memory modules and configuring dual channel mode.
Instructions on how to enter BIOS Setup and basic navigation methods.
Guide to M.I.T. settings for adjusting CPU, memory, and system frequencies and voltages.
Displays current CPU/memory frequencies, temperatures, and voltages.
Options to save changes, exit without saving, or load optimized defaults.
Steps to prepare a USB drive and copy UEFI RAID utility files.
Procedure for launching the UEFI RAID utility and entering commands.
Steps to create a RAID array using commands within the UEFI RAID utility.
How to access the legacy RAID BIOS setup utility after POST.
Steps to create a RAID array using the legacy RAID BIOS interface.
Choosing the RAID mode and specifying the array size in the legacy RAID utility.
Steps to install SATA RAID/AHCI drivers during Windows 8/7 installation.
Methods for preparing a floppy disk with SATA RAID/AHCI drivers for XP.
Procedure for installing SCSI/RAID drivers during Windows XP setup.
Detailed steps for replacing a failed drive and rebuilding a RAID array.
Guide to installing chipset drivers using the Xpress Install utility.
Overview of GIGABYTE's BIOS update tools: Q-Flash and @BIOS.
Step-by-step guide for updating the system BIOS using the Q-Flash utility.
Instructions for updating the system BIOS using the @BIOS Windows utility.
Instructions for backing up and restoring system partitions using Smart Recovery 2.
Frequently Asked Questions and troubleshooting procedures for common problems.