Gigabyte GA-F2A85XM-HD3 - Installing the APU

- 9 -
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 8 x SATA 6Gb/s connectors
 1 x APU fan header
 1 x system fan header
 1 x front panel header
 1 x front panel audio header
 1 x S/PDIF Out header
 1 x USB 3.0/2.0 header
 2 x USB 2.0/1.1 headers
 1 x serial port header
 1 x parallel port header
 1xClearCMOSjumper
 1 x chassis intrusion header
Back Panel
Connectors
 1 x PS/2 keyboard/mouse port
 1 x D-Sub port
 1 x DVI-D port
 1 x HDMI port
 2 x USB 3.0/2.0 ports
 4 x USB 2.0/1.1 ports
 1 x RJ-45 port
 3xaudiojacks(LineIn/LineOut/Microphone)
I/O Controller
 iTE I/O Controller Chip
Hardware
Monitor
 System voltage detection
 APU/System temperature detection
 APU/System fan speed detection
 APU overheating warning
 APU/System fan fail warning
 APU/System fan speed control
* Whether the APU/system fan speed control function is supported will depend on the
APU/system cooler you install.
BIOS  2x64Mbitash
 Use of licensed AMI EFI BIOS
 Support for DualBIOS™
 PnP 1.0a, DMI 2.0, SM BIOS 2.6, ACPI 2.0a
Unique Features  Support for @BIOS
 Support for Q-Flash
 Support for Xpress Install
 Support for EasyTune
* Available functions in EasyTune may differ by motherboard model.
 Support for Smart Recovery 2
 Support for Auto Green
 Support for ON/OFF Charge
 Support for 3TB+ Unlock
 Support for Q-Share