Gigabyte GA-H170TN - SATA Configuration and Device Management

- 28 -
` SATAConguration
& SATA Mode Selection
EnablesordisablesRAIDfortheSATAcontrollersintegratedintheIntelChipsetorcongurestheSATA
controllers to AHCI mode.
AHCI  CongurestheSATAcontrollerstoAHCImode.AdvancedHostControllerInterface(AHCI)
isaninterfacespecicationthatallowsthestoragedrivertoenableadvancedSerialATA
features such as Native Command Queuing and hot plug. (Default)
RAID Enables RAID for the SATA controller.
& Serial ATA Port 0/Serial ATA Port 1/Serial ATA Port 2/Serial ATA Port 3/M.2
 ThecategoryidentiesSerialATAandM.2typesofharddiskthatareinstalledinthecomputer.System
will automatically detect HDD type.
 Notethatthespecicationsofyourdrivemustmatchwiththedrivetable.Theharddiskwillnotworkproperly
if you enter improper information for this category.
Hard drive information should be labeled on the outside device casing. Enter the appropriate option based
on this information.
` PCH-FWConguration
 Thissectionallowsyoutocongureallperipheraldevices.
` NCT5526DSuperIOConguration
& SerialPort1Conguration
 ThissectionprovidesinformationonthesuperI/Ochipandallowsyoutoconguretheserialport.
` Hardware Monitor
Press Enter to view the Hardware Monitor screen which displays a real-time record of the CPU/system
temperature, and fan speed.
& CPU/System FAN Fail Warning
Enable CPU/System Fan Stop Warning function.
Option available: Enabled/Disabled. Default setting is Enabled.
& CPU/System Fan Speed Control
Enable CPU/System Smart Fan function.
Option available: Normal/Performance/Silent. Default setting is Normal.
& System FAN Type
Select system fan type.
Option available: 3 Pins/4 Pins. Default setting is 4 Pins.
` NetworkStackConguration
& Network Stack
Disables or enables booting from the network to install a GPT format OS, such as installing the OS from
the Windows Deployment Services server. (Default: Disabled)