Gigabyte GA-H170TN - Save & Exit BIOS Options

- 35 -
2-6 Save & Exit Menu
The Exit menu displays the various options to quit from the BIOS setup. Highlight any of the exit options then
press Enter.
& Save Changes and Reset
Active this option to reset system after saving the changes.
Options available: Yes/No.
& Discard Changes and Reset
Active this option to reset system after without saving any changes.
Options available: Yes/No.
& Restore Defaults
Press <Enter> on this item and then press the <Y> key to load the default BIOS settings.
Options available: Yes/No.
& Boot Override
 PressEntertocongurethedeviceastheboot-updrive.
& Realtek PXE B01 D00
Allows you to select whether to enable the legacy option ROM for the LAN controller.
& UEFI: Built-in in EFI Shell
 Press<Enter>onthisitemtoLaunchEFIShellfromlesystemdevice.
& LaunchEFIShellfromlesystemdevice
 AttemptstoLaunchEFIShellapplication(SHell.d)fromoneoftheavailablelesystemdevices.
& Me FW Image Re-Flash
 ActivethisoptiontoreashFirmware.
Bios Setup Utility
Save & ExitSecurityMain
Save Options
Save Changes and Reset
Discard Changes and Reset
Default Options
Restore Defaults
Boot Override
Realtek PXE B01 D00
UEFI: Built-in EFI Shell
 LaunchEFIShellfromlesystemdevice
Me FW Image Re-Flash [Disabled]
gf: Select Screen
hi: Select Item
ENTER: Select
+/-: Change Opt.
F1: General Help
F3: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Advanced Chipset Boot