GA-K8U Motherboard - 36 -
English
2-4 Power Management Setup
ACPI Suspend Type
S1(POS) Set ACPI suspend type to S1/POS(Power On Suspend). (Default value)
S3(STR) Set ACPI suspend type to S3/STR(Suspend To RAM).
AC BACK Function
Soft-Off When AC-power back to the system, the system will be in "Off" state. (Default value)
Full-On When AC-power back to the system, the system always in "On" state.
Memory When AC-power back to the system, the system will return to the Last state before
AC-power off.
Soft-Off by PWRBTN
Instant-off Press power button then Power off instantly. (Default value)
Delay 4 Sec. Press power button 4 seconds to Power off. Enter suspend if button is pressed less
than 4 seconds.
PME Event Wake Up
This feature requires an ATX power supply that provides at least 1A on the 5VSB lead.
Disabled Disable this function.
Enabled Enable PME as wake up event. (Default value)
Modem Ring Resume
An incoming call via modem can awake the system from any suspend state.
Disabled Disable Modem Ring Resume function.
Enabled Enable Modem Ring Resume function. (Default value)
USB Dev WakeUp From S3
You can enable this function when ACPI Suspend Type set to S3(STR).
Disabled Disable this function. (Default value)
Enabled Enable USB device can wakeup system from S3.
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Power Management Setup
ACPI Suspend Type [S1(POS)]
AC BACK Function [Soft-Off]
Soft-Off by PWRBTN [Instant-off]
PME Event Wake Up [Enabled]
Modem Ring Resume [Enabled]
USB Dev WakeUp From S3 [Disabled]
Resume by Alarm [Disabled]
x Date (of Month) Alarm Everyday
x Time (hh:mm:ss) Alarm 0 : 0 : 0
POWER ON Function [Disabled]
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level`
To Next Page
Loading...
