GA-M61PME-S2P Motherboard - 38 -
Password Check
Specifies whether a password is required every time the system boots, or only when you enter
BIOS Setup. After configuring this item, set the password(s) under the Set Supervisor/User
Password item in the BIOS Main Menu.
Setup A password is only required for entering the BIOS Setup program. (Default)
System A password is required for booting the system and for entering the BIOS Setup
program.
HDD S.M.A.R.T. Capability
Enables or disables the S.M.A.R.T. (Self Monitoring and Reporting Technology) capability of your
hard drive. This feature allows your system to report read/write errors of the hard drive and to
issue warnings when a third party hardware monitor utility is installed. (Default: Disabled)
Away Mode
Enables or disables Away Mode in Windows XP Media Center operating system. Away Mode
allows the system to silently perform unattended tasks while in a low-power mode that appears off
(Default: Disabled)
Init Display First
Specifies the first initiation of the monitor display from the installed PCI graphics card, PCI Express
graphics card, or the onboard VGA.
PCI Slot Sets the PCI graphics card as the first display.
Onboard VGA Sets the onboard VGA as the first display.
PEG Sets PCI Express graphics card as the first display. (Default)
Frame Buffer Size
Frame buffer size is the total amount of system memory allocated solely for the onboard graphics
controller. MS-DOS, for example, will use only this memory for display. Options are: 32M, 64M
(default),128M, 256M, Disabled.
Onboard GPU
Enables or disables the onboard VGA function.
Enable If No Ext PEG
Activates the onboard VGA only if no PCI Express VGA card is installed. (Default)
Always Enable
Always activates the onboard VGA, whether or not a PCI Express card is installed. If you wish to
set up a dual view configuration, set this item to Always Enable.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
