Hardware Installation- 11 -
Internal Connectors 1 x serial port header
1 x power LED header
1 x chassis intrusion header
Back Panel 1 x PS/2 keyboard port
Connectors 1 x Parallel port
1 x D-Sub port
1 x DVI-D port
(Note 6)
1 x HDMI port
1 x optical S/PDIF Out connector
4 x USB 2.0/1.1 ports
1 x RJ-45 port
3 x audio jacks (Line In/Line Out/Microphone)
I/O Controller iTE IT8718 chip
Hardware Monitor System voltage detection
CPU/System temperature detection
CPU/System fan speed detection
CPU overheating warning
CPU/System fan fail warning
CPU fan speed control
(Note 7)
BIOS 1 x 4 Mbit flash
Use of licensed AWARD BIOS
PnP 1.0a, DMI 2.0, SM BIOS 2.4, ACPI 1.0b
Unique Features Support for @BIOS
Support for Download Center
Support for Q-Flash
Support for EasyTune
(Note 8)
Support for Xpress Install
Support for Xpress Recovery2
Support for Virtual Dual BIOS
Bundled Software Norton Internet Security (OEM version)
Operating System Support for Microsoft
®
Windows
®
Vista/XP
Form Factor Micro ATX Form Factor; 24.4cm x 21cm
(Note 1) Due to Windows XP 32-bit operating system limitation, when more than 4 GB of physical
memory is installed, the actual memory size displayed will be less than 4 GB.
(Note 2) Whether 1066 MHz memory speed is supported depends on the CPU being used.
(Note 3) To configure 7.1-channel audio, you need connect with the port of HD Audio standard via
front panel and enable the multi-channel audio feature through the audio driver.
(Note 4) Whether Hybird SLI technology is supported depends on the graphics card being used.
(Note 5) Due to a chipset limitation, the SATA2_4/SATA2_5 connectors only support AHCI/RAID mode.
(Note 6) The DVI-D port does not support D-Sub connection by adapter.
(Note 7) Whether the CPU fan speed control function is supported will depend on the CPU cooler you
install.
(Note 8) Available functions in Easytune may differ by motherboard model.
To Next Page
Loading...
