- 47 - BIOS Setup
2-9 MB Intelligent Tweaker(M.I.T.)
Incorrectly doing overclock/overvoltage may result in damage to CPU, chipset, or memory
and reduce the useful life of these components. This page is for advanced users only and we
recommend you not to alter the default settings to prevent system instability or other unex-
pected results. (Inadequately altering the settings may result in system's failure to boot. If this
occurs, clear the CMOS values and reset the board to default values.)
CPU Frequency (MHz)
Allows you to manually set the CPU host frequency.
Important It is highly recommended that the CPU frequency be set in accordance with the CPU
specifications.
HT Link Frequency
Allows you to manually set the frequency for the HT Link between the CPU and chipset.
Auto BIOS will automatically adjust the HT Link Frequency. (Default)
200 MHz~1 GHz Sets HT Link Frequency to 200 MHz~1 GHz.
PCIE Clock (MHz)
Allows you to manually set the PCIe clock frequency. The adjustable range is from 100 MHz to
200 MHz. Auto sets the PCIe clock frequency to standard 100 MHz. (Default: Auto)
CPU Clock Ratio
Allows you to alter the clock ratio for the installed CPU. The adjustable range is dependent on the
CPU being used.
Memory Controller Freq.
(Note)
Allows you to alter the memory controller frequency for the installed CPU. The adjustable range is
dependent on the CPU being used.
(Note) This item is present only if you install a CPU that supports this feature.
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
MB Intelligent Tweaker(M.I.T.)
CPU Frequency [200]
HT Link Frequency [Auto]
PCIE Clock [100]
CPU Clock Ratio [Auto]
Memory Controller Freq.
(Note)
[Auto] 1800Mhz
` DRAM Configuration [Press Enter]
DDR2 Voltage Control [Normal]
CPU NB VID Control
(Note)
[Normal]
CPU Voltage Control [Normal]
Normal CPU Vcore 1.3500V
KLJI: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level`
To Next Page
Loading...
