Gigabyte GA-M85M-US2H - Page 44

GA-M85M-US2H Motherboard - 44 -
Password Check
Specifies whether a password is required every time the system boots, or only when you enter
BIOS Setup. After configuring this item, set the password(s) under the Set Supervisor/User
Password item in the BIOS Main Menu.
Setup A password is only required for entering the BIOS Setup program. (Default)
System A password is required for booting the system and for entering the BIOS Setup
program.
HDD S.M.A.R.T. Capability
Enables or disables the S.M.A.R.T. (Self Monitoring and Reporting Technology) capability of your
hard drive. This feature allows your system to report read/write errors of the hard drive and to
issue warnings when a third party hardware monitor utility is installed. (Default: Disabled)
Away Mode
Enables or disables Away Mode in Windows XP Media Center operating system. Away Mode
allows the system to silently perform unattended tasks while in a low-power mode that appears off
(Default: Disabled)
Backup BIOS Image to HDD
Allows the system to copy the BIOS image file to the hard drive. If the system BIOS is corrupted,
it will be recovered from this image file. (Default: Enabled)
Hybrid SLI
Enables or disables the Hybrid SLI function. This item is automatically set to Enabled when a
Hybrid SLI-supported graphics card is installed.
Display Detection
This item is configuable when Hybrid SLI is enabled. Enabled allows the BIOS to automatically
detect whether the current display is from the onboard VGA or a PCI Express graphics card and
to change the current display if it is different from the Init Diplay First setting.
Init Display First
Specifies the first initiation of the monitor display from the installed PCI graphics card, PCI Express
graphics card or the onboard VGA. (Only Onboard VGA and PEG are available for selection when
Hybrid SLI is enabled.)
PCI Slot Sets the PCI graphics card as the first display.
Onboard VGA Sets the onboard VGA as the first display.
PEG Sets the PCI Express graphics card oas the first display. (Default)
iGPU Frame Buffer Control
Determines whether to manually set the Frame Buffer Size. Auto lets the BIOS automatically set
the Frame Buffer Size as required. Manual allows the Frame Buffer Size item below to be
configurable. (Default: Auto. This item is automatically set to Manual when Hybrid SLI is enabled.)