Gigabyte GA-P41T-USB3L - Page 35

- 35 - BIOS Setup
********
DRAM Performance Control
********
Performance Enhance
Allows the system to operate at three different performance levels.
Standard Lets the system operate at its basic performance level. (Default)
Turbo Lets the system operate at its good performance level.
Extreme Lets the system operate at its best performance level.
(G)MCH Frequency Latch
 Allowsyoutoxthechipsetfrequencyatsystembootup.Optionsforadjustingmemorymultiplierbelow
maydifferaccordingtothexedfrequency.Optionsare:Auto(default),200MHz,266MHz,333MHz.
System Memory Multiplier (SPD)
Allows you to set the system memory multiplier. Options are dependent on CPU FSB and the (G)MCH
Frequency Latch settings. Auto sets memory multiplier according to memory SPD data. (Default: Auto)
Memory Frequency (Mhz)
 The rstmemory frequencyvalueis the normaloperating frequencyofthememory beingused;the
second is the memory frequency that is automatically adjusted according to the CPU Host Frequency
(Mhz) and System Memory Multiplier settings.
DRAM Timing Selectable (SPD)
Manual allowsall DRAMtiming control itemsbelow to be congurable.Optionsare:Auto(default),
Manual.
>>>>> Standard Timing Control
CAS Latency Time
Options are: Auto (default), 4~11.
tRCD
Options are: Auto (default), 1~15.
tRP
Options are: Auto (default), 1~15.
tRAS
Options are: Auto (default), 1~63.