Gigabyte GA-X58A-UD7 - Page 120

Appendix - 120 -
• Rebuilding in the operating system
MakesuretheJMicronJMB362/GIGABYTESATA2SATAcontrollerdriverhasbeeninstalledfromthemoth-
erboard driver disk. Launch the GIGABYTE RAID CONFIGURER from All Programs in the Start menu.
Step 1:
In the GIGABYTE RAID CONFIGURER screen,
right-click on the array to be rebuilt in the RAID
LIST block. Select Rebuild Raid. (Or click the
Rebuild icon in the tool bar.)
Step 3:
Select a drive to rebuild the array and click Next.
Step 2:
When the Rebuilding RAID Wizard appears,
click Next.
Step 4:
Click Finish to start the RAID rebuilding process.
Step 6:
Whennished,restartyoursystem.
Step 5:
The rebuilding progress is displayed at the
bottom of the screen.