BIOS Setup - 38 -
M.I.T. Current Status `
This screen provides information on CPU/memory frequencies/parameters.
BCLK/PCIe Clock Control &
Enables or disables the control of CPU base clock and PCIe bus frequency. Enabled will allow the Host
Clock Frequency and Processor Base Clock
to boot after overclocking, please wait for 20 seconds for automated system reboot, or clear the CMOS
values to reset the board to default values. (Default: Disabled)
Host Clock Frequency &
Allows you to manually set the host clock frequency (which controls CPU, PCIe, and memory frequencies) in
BCLK/PCIe Clock Control is enabled. When you
change the Host Clock Frequency setting, the Memory Frequency (Mhz) setting below will be changed
synchronously.
Important:
Processor Base Clock &
Processor Base Clock by multiplying the Host Clock Frequency by several
BCLK/PCIe Clock Control is enabled.
When you change the Processor Base Clock setting, the Memory Frequency (Mhz) setting below will be
changed synchronously.
Important:
CPU Clock Ratio &
Allows you to alter the clock ratio for the installed CPU. The adjustable range is dependent on the CPU
being installed.
CPU Frequency &
This value is determined by multiplying the Processor Base Clock value by the CPU Clock Ratio
value.
Advanced Frequency Settings `
To Next Page
Loading...
