- 57 - BIOS Setup
(Note) Supported on Windows 7/Vista operating system only.
S3(Suspend to RAM) Enables the system to enter the ACPI S3 sleep state. In S3 sleep state, the
system appears to be off and consumes less power than in the S1 state. When
signaled by a wake-up device or event, the system resumes to its working
state exactly where it was left off. (Default)
Suspend Disabled Disables this function.
High Precision Event Timer &
(Note)
Enables or disables High Precision Event Timer (HPET) for Windows 7/Vista operating system. (Default:
Enabled)
Soft-Off by PWR-BTTN &
Instant-Off Press the power button and then the system will be turned off instantly.
(Default)
Delay 4 Sec. Press and hold the power button for 4 seconds to turn off the system. If the
power button is pressed for less than 4 seconds, the system will enter suspend
mode.
Wake on LAN from S5 &
Allows the system to be awakened from S5 ACPI sleep state by a wake-up signal from the onboard LAN.
(Default: Enabled)
ErP Support &
Determines whether to let the system consume less than 1W power in S5 (shutdown) state. (Default:
Disabled)
Note: When this item is set to Enabled, the following functions will become unavailable: PME event wake
up, power on by mouse, power on by keyboard, and wake on LAN.