Appendix - 90 -
Delete the RAID Array:
To deleted the existing array, press <Enter> on the RAID tab and select Delete VD. When the Delete VD menu
appears, press <Enter> on the array to select it and then press <Enter> on NEXT. When prompted, press <Y>
When the message "Do you want to delete the VD's MBR?" appears, press <Y> to
clear the MBR or press other keys to ignore.
Figure 10
[ Adapter] [ Devices]
Marvell BIOS Setup (c) 2009 Marvell Technology Group Ltd.
[ RAID ]
Create the VD?[Y]
ID Name Size Level Status Stripe CacheMode
* 0 GBT 152.4GB RAID0 ONLINE 64KB WriteBack
NEXT
Delete VD
Use the Marvell Storage Utility in the Operating System:
With the Marvell Storage utility, you can set up an array or view the current array status in the operating
system. To install the utility, insert the motherboard driver disk, then go to Application Software\Install
Application Software and select Marvell Storage Utility to install. Note: After the installation, you must
login the utility with the same account name and password that you use to login the operating system.
If you did not set the account password before, click Login to enter the Marvell Storage Utility directly.
Please note that if you set the hard drive(s) to IDE or AHCI mode, it is normal that you will not see the hard
drive(s) in the Marvell Storage Utility.
To Next Page
Loading...
