- 95 - Appendix
Performing the Rebuild in the Operating System •
While in the operating system, make sure the Chipset driver and Intel Rapid Storage Technology Enter-
prise RAID Port Drivers have been installed from the motherboard driver disk. Then launch Intel Rapid
Storage Technology enterprise from All Programs in the Start menu.
Step 1:
On the right panel of the screen, click Rebuild
to another disk under Volume Properties.
The Status item on the right of the screen and
the Information section on the bottom display
the rebuild progress.
Step 2:
Select a new drive to rebuild the RAID and click
Rebuild.
Step 3:
After the RAID volume rebuilding, the Status will
display as Normal.
To Next Page
Loading...
