Gigabyte GA-Z87MX-D3H - Page 46

BIOS Setup
- 46 -
& CPU Vcore/CPU VRIN/DRAM Voltage/+3.3V/+5V/+12V/CPU VAXG
Displays the current system voltages.
& CPU/System/PCH Temperature
Displays current CPU/Chipset/System temperature.
& CPU/CPU OPT/System Fan Speed
Displays current CPU/CPU_OPT/system fan speeds.
& CPU/System Temperature Warning
Sets the warning threshold for CPU/system temperature. When CPU/system temperature exceeds
thethreshold,BIOS willemitwarningsound.Options are:Disabled(default), 60
o
C/140
o
F, 70
o
C/158
o
F,
80
o
C/176
o
F, 90
o
C/194
o
F.
& CPU/CPU OPT/System Fan Fail Warning
Allows the system to emit warning sound if the fan is not connected or fails. Check the fan condition or fan
connectionwhenthisoccurs.(Default:Disabled)
& CPU/OPT Fan Speed Control (CPU_FAN/CPU_OPT Connectors)
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Normal Allows the fan to run at different speeds according to the CPU temperature. You can adjust
thefanspeedwithEasyTunebasedonyoursystemrequirements.(Default)
Silent Allows the fan to run at slow speeds.
Manual Allows you to control the fan speed under the Slope PWM item.
Silent Allows the fan to run at slow speeds.
& Slope PWM
 Allowsyoutocontrolthefanspeed.ThisitemiscongurableonlywhenCPU/OPT Fan Speed Control is
set to Manual. Options are: 0.75 PWM value /
o
C ~ 2.50 PWM value /
o
C.
& 1st System Fan Speed Control (SYS_FAN1 Connector)
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Normal Allows the fan to run at different speeds according to the system temperature. You can adjust
thefanspeedwithEasyTunebasedonyoursystemrequirements.(Default)
Silent Allows the fan to run at slow speeds.
Manual Allows you to control the fan speed under the Slope PWM item.
Disabled Allows the fan to run at full speeds.
& Slope PWM
 Allowsyoutocontrolthefanspeed.Thisitemiscongurableonlywhen1st System Fan Speed Control
is set to Manual. Options are: 0.75 PWM value /
o
C ~ 2.50 PWM value /
o
C.
& 2nd/3rd System Fan Speed Control (SYS_FAN2/ SYS_FAN3 Connectors)
Allows you to determine whether to enable the fan speed control function and adjust the fan speed.
Normal Allows the fan to run at different speeds according to the system temperature. You can adjust
thefanspeedwithEasyTunebasedonyoursystemrequirements.(Default)
Silent Allows the fan to run at slow speeds.
Manual Allows you to control the fan speed under the Slope PWM item.
Disabled Allows the fan to run at full speeds.
& Slope PWM
 Allowsyoutocontrolthefanspeed.Thisitemiscongurableonlywhen2nd/3rd System Fan Speed
Control is set to Manual. Options are: 0.75 PWM value /
o
C ~ 2.50 PWM value /
o
C.