Gigabyte H282-Z60 - Installing the Mezzanine Card; Installing the OCP 3.0 Mezzanine Card

- 37 - System Hardware Installation
3-11 Installing the Mezzanine Card
3-11-1 Installing the OCP 3.0 Mezzanine Card
UseofthefollowingtypeofOCP3.0NICisrecommended:
• OCP 3.0 SFF with pull tab
• OCP 3.0 SFF with ejector latch
Follow these instructions to install an OCP 3.0 Mezzanine card:
1. Remove the one screw securing the OCP 3.0 card slot cover.
2. Remove the slot cover from the system.
3. Insert the OCP 3.0 card into the card slot ensuring that the card is rmly connected to the connector
on the motherboard.
4. Tighten the thumbnail screw to secure the OCP 3.0 card in place.
5. Reverse steps 3-4 to replace the OCP 3.0 card.
1
2
3
4