Need help?Do you have a question about the Gigabyte MS03-6L0 and is the answer not in the manual?
General| Brand | Gigabyte |
|---|---|
| Model | MS03-6L0 |
| Category | Motherboard |
| Language | English |
Guidelines for safe and proper installation of motherboard components.
Details on form factor, CPU, chipset, memory, LAN, graphics, audio, storage.
Step-by-step instructions for safely installing and removing the CPU.
Procedures for installing DDR5 DIMMs and configuring memory.
Instructions for installing M.2 SSD devices with heat sinks.
Identification and function of connectors on the motherboard's rear panel.
Identification and function of various internal connectors on the motherboard.
Configuration options via jumpers for BIOS recovery, CMOS clear, etc.
Overview of the BIOS Setup program's main interface and navigation.
Configuration options for hardware components and system functions.
BIOS support for security devices like TPM.
Configuration for managing the system remotely via serial port.
Settings for Super IO chip and serial port configurations.
Configuration of PCI/PCIe slots, lanes, and link speeds.
Settings for USB devices, hand-off, and legacy support.
Configuration for UEFI network stack and PXE/HTTP boot.
Settings for POST error messages and system halt behavior.
Settings for NVMe devices and LED control.
Power state resume, security settings for storage devices.
Configuration for TLS authentication, certificate enrollment.
Configuration for iSCSI initiator and boot parameters.
Configuration for the Intel i210 Gigabit network controller.
Configuration for Virtual LAN (VLAN) ID and priority.
Configuration for the Broadcom 10GbE Ethernet controller.
Displays driver health status for installed devices/controllers.
Configuration options for the Platform Controller Hub (PCH).
Settings related to the CPU, including frequency, cache, and features.
Configuration for dividing NUMA nodes for performance.
Settings for the UPI (Ultra Path Interconnect) configuration.
Settings for memory frequency, ADR, and RAS configuration.
Configuration for Intel VT for Directed I/O and VMD technology.
Settings for CPU power states, C-states, and energy performance.
Configuration for SATA, RST, and other PCH-related settings.
Settings for active video and spread spectrum.
Information and status for the Server Management Engine (ME) firmware.
Configuration for system error logging and WHEA support.
Settings for power policy quick settings and CPU power management.
Options for managing server hardware and BMC.
Configuration for enabling and managing system event logging.
Displays basic system ID and product information.
Configuration for BMC VLAN ID and priority.
Configuration for BMC network settings, IP, and MAC addresses.
Configuration for IPv6 BMC network settings.
Options for safeguarding the system with passwords.
Configuration for Secure Boot functionality and key management.
Settings for drive priority and boot-up behavior.
Options to save changes, discard changes, and exit BIOS setup.
Instructions for recovering the BIOS in case of corruption.
Codes indicating system status based on beep patterns.
To Next Page
