Gigabyte R182-Z91 - Ocp 2.0

System Hardware Installation - 37 -
3-7-2 OCP 2.0
Follow these instructions to install an OCP 2.0 mezzanine card:
1. Loosenthethumbscrewontheriserbracket
2. Liftuptheriserbracketoutofsystem.
3. Remove the screw securing the mezzanine card slot cover.
4. Remove the slot cover from the system..
5. InserttheOCP2.0mezzaninecardintothecompartmentensuringthatthecardisrmlyconnected
to the connector on the motherboad.
6. SecuretheOCP2.0mezzaninecardintothesystemwiththreescrews.
7. Reversesteps5-6toreplacetheOCP2.0mezzaninecard.
1
2
5
6
4
3