Gigabyte R262-ZA0 - Page 14

Hardware Installation - 14 -
Internal I/O
 1 x M.2 slot
 1 x USB 3.0 header
 1 x COM header
 1 x TPM header
 1 x OCP 3.0 mezzanine slot
 1 x OCP 2.0 mezzanine slot
 1 x Front panel header
 1 x HDD back plane board header
 1 x PMBus connector
 1 x IPMB connector
 1 x Clear CMOS jumper
 1 x BIOS recovery jumper
Front I/O
 2 x USB 3.0
 1 x Power button with LED
 1 x ID button with LED
 1 x NMI button
 1 x Reset button
 2 x LAN activity LEDs
 1 x HDD activity LED
 1 x System status LED
Rear I/O
 2 x USB 3.0
 1 x VGA
 2 x RJ45
 1 x MLAN
 1 x ID button with LED
Backplane I/O
 Front side_CBP20O8: 24 x SATA/SAS ports
 Rear side_CBP10A5: 8 x SATA/SAS, 2 x U.2 ports
 Internal_CBP2080: 8 x SATA/SAS ports
 Speed and bandwidth:
 SAS 12Gb/s, SATA 6Gb/s, and PCIe Gen4 x4
TPM
 1 x TPM header with SPI interface
 Optional TPM2.0 kit: CTM010