Gigabyte X299-WU8 - Page 68

Conguring a RAID Set
- 68 -
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
B.ConguringSATAcontrollermodeinBIOSSetup
MakesuretoconguretheSATAcontrollermodecorrectlyinsystemBIOSSetup.
Step 1:
Turnonyourcomputerandpress<Delete>toenterBIOSSetupduringthePOST(Power-OnSelf-Test).Goto
Peripherals\SATAAndRSTConguration, make sure SATA Controller(s)isenabled.TocreateRAID,set
SATA Mode Selection to Intel RST Premium(Figure1).Note:WhenusingaPCIeSSD,makesuretosetthe
Use RST Legacy OROM item under Peripherals\SATAAndRSTConguration to Disabled. Then depending
the M.2 connector you use. Finally, save the settings and exit BIOS Setup.
Step 2:
TousetheEZRAIDfeature,followthestepsin"C-1."TocongureUEFIRAID,followthestepsin"C-2."To
enterthelegacyRAIDROM,referto"C-3"formoreinformation.Finally,savethesettingsandexitBIOSSetup.
Figure 1