- 6 -
1-3 Using Q-Flash Plus
A. Before You Begin
1. From GIGABYTE's website, download the latest compressed BIOS update le that matches your motherboard
model.
2. Uncompress the downloaded BIOS le, save it to your USB ash drive, and rename it to GIGABYTE.bin.
Note: The USB ash drive must use the FAT32/16 le system and it must be a USB 2.0 ash drive.
3. Insert the USB ash drive into the white USB port on the back panel.
B. Using Q-Flash Plus
If both the main and backup BIOS fail during system boot, wait for 15-20 seconds, the system will automatically
search and match the BIOS le in the USB ash drive on the white USB port. The FBIOS_LED will ash when
the BIOS matching and ashing activities start.
Wait for 2-3 minutes and the FBIOS_LED will stop ashing when the main BIOS ashing is complete.
After the main BIOS is ashed, the system will reboot automatically and then DualBIOS
™
will
continue to update the backup BIOS. After completion, the system will reboot again and boot from
the main BIOS for normal operation.