Gigabyte Z490 VISION D - Page 29

- 29 -
Hardware Installation
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power
cord from the power outlet to prevent damage to the devices.
For how to turn on/off the lights of the LED strip, refer to the instructions on in Chapter 5, "Unique
Features,""APPCenter\RGBFusion."
10) LED_C1/LED_C2(RGBLEDStripHeaders)
 Theheaderscanbeusedtoconnectastandard5050RGBLEDstrip(12V/G/R/B),withmaximumpower
rating of 2A (12V) and maximum length of 2m.
Connectone end of the RGB LED strip
extension cable to the header and the other
endtoyourRGBLEDstrip.Theblackwire(markedwithatriangleontheplug)
of the extension cable must be connected to Pin 1 (12V) of this header. The
12V pin (marked with an arrow) on the other end of the extension cable must be
lined up with the 12V of the LED strip. Be careful with the connection orientation
of the LED strip; incorrect connection may lead to the damage of the LED strip.
12VRGB
BG12VR
12V
1
RGBLED
Strip
12VRGB
BG12VR
Pin No. Denition
1 12V
2 G
3 R
4 B
1
LED_C2
1
LED_C1
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
11) SATA3 0/1/2/3/4/5 (SATA 6Gb/s Connectors)
The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Intel
®
ChipsetsupportsRAID0,
RAID1,RAID5,andRAID10.RefertoChapter3,"ConguringaRAIDSet,"forinstructionsonconguring
aRAIDarray.
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
SATA3
3 5 1
2 4 0
To enable hot-plugging for the SATA ports, refer to Chapter 2, "BIOS Setup," "Settings\IO Ports\
SATAAndRSTConguration,"formoreinformation.
1
1
7
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
7