Gigabyte Z490 VISION D - Page 68

- 68 -
Conguring a RAID Set
Step 3:
On the Intel(R) Rapid Storage Technology menu, press <Enter> on Create RAID Volume to enter the Create
RAID Volume screen. Enter a volume name with 1~16 letters (letters cannot be special characters) under the
Nameitemandpress<Enter>.Then,selectaRAIDlevel(Figure8).RAIDlevelssupportedincludeRAID0,
RAID1,RAID10,andRAID5(theselectionsavailabledependonthenumberoftheharddrivesbeinginstalled).
Next, use the down arrow key to move to Select Disks.
Step 4:
Under Select Disks
item,selecttheharddrivestobeincludedintheRAIDarray.Pressthe<Space>keyon
the hard drives to be selected (selected hard drives are marked with "X"). Then set the stripe block size (Figure
9). The stripe block size can be set from 4 KB to 128 KB. Once you have selected the stripe block size, set
the volume capacity.
Figure 8
Figure 9