Made in Germany
© Gigahertz Solutions GmbH - 5 - May 2017
3 LEDs / Display / Audio
Signals
3.1 LEDs and Display
The measured value shown on the display...
…is the unit adjacent to the solid green LED
(primary measurement).
A flashing LED indicates the unit of the second-
ary measurement, which can be selected by de-
pressing the “Mode>” button.
In fields of very high magnetic intensity, the val-
ue will be displayed in uT (microTesla), indicated by the red
LED “X 1000”. Also the green LED will then turn red indicat-
ing a change of scale. Both LEDs will start flashing red when
the measured values are higher than the instrument can dis-
play. Similarly, when measuring body voltage, a change from
mV to V for higher values is indicated.
Special LCD Display Messages
“Low Batt“: The rechargeable battery is low – please charge
the battery
“Err.“: Short for ‘Error’. Indicates an erroneous configura-
tion. This can occur when a grounding cable or mains
adapter is connected and potential-free E-field measure-
ment is selected. Select a different setting!
„----“: Instrument is in the process of determining the meas-
urement, or the value is too small to be measured.
„CHAr“: Instrument is being charged. (For technical reasons “FULL”
will be shown shortly before this, which is to be ignored)
„FULL“: During the charging process, with the mains adap-
tor connected, this indication means: charging process
completed, battery loaded. During normal operation, how-
ever, “FULL” means the SD memory card is full.
„nbAt“: The processor cannot recognize the battery (see the
note below)
To Next Page
Loading...
Need help?
General
