Gigaset COMFORT 552 A / LUG_Kombi_USA US en / A31008-M3001-R301-1-3S19 / applications_1.fm / 5/31/22
Template Module, Version 2.1, 11.08.2020 / Template Basiseinstellungen: Version 3.1 - 07.07.2020
Baby monitor
43
Alarm
An alarm is shown on the display and indicated by the selected ringtone melody. The alarm
sounds for 60 seconds. If no key is pressed, the alarm is repeated after 5 minutes. After the
second
repetition, the alarm call is deactivated for 24 hours.
Switching off/repeating the alarm after an interval (snooze mode)
Deactivate the alarm: Off
Repeat the alarm (snooze mode): Press Sn
ooze or any key . . . the alarm is switched off and
repeated after 5 minutes.
Baby monitor
When the baby monitor is switched on, the stored (internal or external) destination number is
called as soon as a defined noise level is exceeded in the vicinity of the handset. The alarm to an
external number is cancelled after approximately 90 seconds.
You can answer the alarm using the Tw
o Way Talk function. This function is used to switch the
loudspeaker of the handset located in the baby's room on or off.
In baby monitor mode, incoming calls ar
e only indicated on the display (without ringtone). The
display backlight is reduced to 50%. Advisory tones are deactivated. All keys are locked, with the
exception of the display keys and the centre of the control key.
If you accept an incoming call, the baby monitor mo
de is suspended for the duration of the call,
but the function remains activated. The baby monitor mode is not deactivated by switching the
handset off and on again.
During a call, the alarm is only indicated by a short tone.
The handset should be positioned 1 to 2 metres away from the baby. The microphone
must point towards the baby.
Activating the function reduces the operating time of your handset. For that reason,
place the handset in the charging cradle if necessary.
The baby monitor is activated 20 seconds after switching on.
The microphone of the handsfree device is always used, even if a headset is connected.
The answer machine for the destination number must be switched off.
After switching on:
Test sensitivity.
Test the connection, if the alarm is being forwarded to an external number.
To Next Page
Loading...
Need help?
General
