A certain lowering of the level is caused by wear on the brake pads. Should the level
appear to be below the minimum mark, please contact an Authorised Service Centre
or Dealer in order to have a thorough inspection of the braking system carried out.
03_22
Brakingsystemfluidtopup (03_22)
Proceed as follows: Unscrew the two screws «B», remove the fuel tank cap and the
intermediate rubber membrane, and top-up the brake fluid level using only the rec-
ommend brake fluid type and without exceeding the maximum level.
Under standard climatic conditions, replace fluid as indicated in the scheduled main-
tenance table. This operation must be carried out by trained technicians; take your
scooter to an authorised Service Centre or Dealer.
WARNING
ONLY USE DOT 4-CLASSIFIED BRAKE FLUID. BRAKE CIRCUIT FLUID IS VERY
CORROSIVE; MAKE SURE THAT IT DOES NOT COME INTO CONTACT WITH
THE PAINTWORK.
CAUTION
AVOID CONTACT OF BRAKE FLUID WITH EYES, SKIN, AND CLOTHING. IN
CASE OF CONTACT, RINSE WITH WATER. THE BRAKING CIRCUIT FLUID IS
HYGROSCOPIC, THAT IS, IT ABSORBS HUMIDITY FROM THE SURROUNDING
AIR. IF THE HUMIDITY IN THE BRAKING FLUID EXCEEDS A CERTAIN VALUE,
IT WILL LEAD TO INEFFICIENT BRAKING. NEVER USE BRAKING FLUID KEPT
IN CONTAINERS THAT HAVE ALREADY BEEN OPENED, OR PARTIALLY USED.
Recommended products
AGIP BRAKE 4
Brake fluid.
55
To Next Page
Loading...
Need help?
General
