Gilson Company, Inc. Gilson Binder Ignition System: HM-378
Page 2
Table of Contents
Page
1.0 Important Notice - Initial Unpacking 3
2.0 Introduction 3
3.0 Important Safety Rules 3
4.0 Unpacking & Setting Up Furnace 4
5.0 Where to Locate Furnace 4
6.0 Seating the Elements 4
7.0 Binder Ignition Test 5
7.1 Introduction 5
7.2 Programming the Controller 5
7.3 Performing a Typical Binder Ignition Test 7
7.4 Shutting Down the Furnace 8
7.5 Aborting a Test 8
8.0 Custom Applications 8
8.1 Ramp-Hold Programming 8
8.2 Delayed Firing Programming 9
9.0 Additional Controller Operating Details 9
10.0 Maintenance 11
10.1 Electrical Problems 11
10.2 Elements 11
10.2.1 Reseating the Elements 11
10.2.2 Replacing Main Chamber Elements 12
10.2.3 Replacing Afterburner Elements 13
10.3 Firebrick Damage 14
11.0 The Temperature Controller - Troubleshooting 15
12.0 Repair & Replacement Parts 17
Figure 1: Parts & Accessories Diagram 18
Figure 2: Control Panel 19
Figure 3: Wiring Diagram, 208—240V, 50/60Hz 20
Figure 4: Ignition Sequence Schematic 21
Figure 5: Fire Brick Replacement Assemblies 22
13.0 Statement of Warranty 23
To Next Page
Loading...