EasyManua.ls Logo

Gin Yeti UL - Rescue System Installation Checks; Test Deployment Verification

Gin Yeti UL
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Yeti UL front container manual: 11
Every first installation of a rescue system into the Yeti UL front container must be checked
by a qualified paragliding professional for compatibility. To verify the installation, you must
perform a test deployment by sitting in a simulator.
Rescue parachutes should be repacked at least every 150 days; so installing your rescue in
a new Yeti UL front container may also provide a good opportunity for a repack. After
every repack of the rescue parachute you should also do a compatibility check.
Rescue compatibility
MAKE SURE THAT THE RESCUE PARACHUTE CAN BE RELEASED FROM THE RESCUE
CONTAINER—it must be done by you, the pilot, sitting in the harness hanging from a
simulator.
WARNING: If you are in any doubt about any aspect of rescue installation, seek
professional advice!
IMPORTANT: You must perform a test deployment from a simulator to verify the
installation.
IMPORTANT: Make sure that both Y-rescue bridle ends are connected with a main
carabiner on each side.