Yeti UL front container manual: 13
Connecting the rescue bridle
We recommend that the rescue is connected with a handshake-knot with the rescue bridle
(see pictures bellow). In case you use a different type of connector like a carabiner, make
sure that it is rated at least 9 times the maximum weight.
It is the pilot’s responsibility to check the compatibility of the rescue system and ensure
that it is installed properly. Be sure to inspect your connection during normal maintenance
and safety checks. Replace it whenever there are any signs of wear and check your rescue
system with a professional after any deployment.
Pass the rescue bridle through the bridle. Secure the connection with a tape
Pull hard to make a clean knot.
ATTENTION: Make sure that the knot is tight. A loose knot might lead to failure in case
the rescue is deployed under high speeds.
In case us use a carabiner to connect your rescue with your rescue bridle:
We recommend that you cover the connection using the Maillon rapid cover to prevent
excess friction. Rubber- bands should also be used to secure the attachment and prevent
excess friction.
Correct carabiner-connection
To Next Page
Loading...