Yeti UL front container manual: 12
Rescue handle attachment
Before you attach the rescue handle, check the length of the strap connecting the rescue
deployment handle to the rescue inner container. It should be long enough that the
reserve can be extracted without the danger of the pins not being pulled before the strap
tightens on the reserve, but not so long that there is excessive slack that extends the
movement required for deployment.
Pass the handle through Pass the handle through Make a loop like shown in
the center loop itself the picture. Pull to make a
clean knot
CAUTION: Please use the center attachment loop. If the handle is connected to the side
loop, Rescue deployment can be delayed or may even be prevented.
IMPORTANT: The deployment bag of other manufacturers’ rescue systems may have
different loop positions which may cause a deployment failure.
To Next Page
Loading...