Once your batteries are correctly connected, you can secure them into
place with the green t shaped battery brackets. Secure with medium bolts
into the battery bracket mounts, below the large tube bench supports, see
images below. Depending on the layout of wires and batteries, the brackets
may be a better fit flipped with the shorter arms on the opposite side.
Step 5 - Rear Bench
With the batteries fully installed and bracketed into place, attach the black
bench support, bolting it into the mounting plates on the tubular bench
supports on either side of the bench area. Once complete, angle the rear
edge of the seat underneath the seat back and push the plastic bench into
place. Secure the front of the seat with screws by aligning the pre made
holes of the bench with the interior body piece behind it.
09
To Next Page
Loading...