Gio Electric Peak - E-bike Control Buttons

Function Buttons
Located on the left handlebar is a set of 3 buttons used to control the
features and setting of your Peak e-bike.
The 3 buttons are: (▲)-Up, (▼)-Down & (M)-Menu and are pressed in 3
ways: SHORT press - single quick press, LONG press - press and hold for 2
seconds, and HOLD press - press and hold for over 5 seconds.
Follow the chart below to perform the specific function or operation:
Turn your e-bike
On/O
LONG press (M)
Adjust Power
Assist(PAS) level
SHORT press (▲) OR (▼) to your desired level
(1-5)
Toggle Speed Display
LONG press (M)+(▲) to cycle
Turn Walk On/O
LONG press and HOLD (▼), release to stop
Turn Cruise On
LONG press (▼) while PAS or throttle is active
Turn Cruise O
Apply brakes or start pedaling while in Cruise
Turn Headlight On/O
LONG press (▲)
Toggle ODO/multi
display options
SHORT press (M)
Enter parameter
settings menu
LONG press (▲)+(▼)
Switch to next
parameter
While in parameter settings menu, SHORT press
(M)
Adjust current
parameter
While in parameter settings menu, SHORT press
(▲) OR (▼)
Save parameters and
exit parameter settings
menu
While in parameter settings menu, LONG press
(▲)+(▼) OR after 10 seconds of inactivity it will
auto-save and exit to the main display screens
The following page contains a list of parameters settings adjusted within
your e-Bikes parameter settings menu. The Peak features an operating
system that has setting options for multiple e-bike models, we strongly
recommend you do not adjust the highlighted settings below as their
presets are specific to your GIO Electric Peak.
12