Operating your eScooter
Accelerating
Acceleration for your eScooter is controlled by the twist grip throttle on the
handlebar. Rotate throttle towards you to accelerate and away from you to
slow down. It’s more efficient if you add power gradually when accelerating
and coast as far as possible before braking.
⚠
ALWAYS KEEP YOUR HANDS ON THE BRAKE LEVERS IN ORDER TO CONTROL
THE SPEED AND TO BE ABLE TO DISENGAGE CRUISE CONTROL.
Braking
Brakes are applied by squeezing the levers that are located on both sides
of the handlebars. Please take extra care to balance between the brakes in
slippery or wet conditions. It is recommended to apply front and rear brakes
together, leading with squeezing the rear lever first.
Charging
⚠
YOUR WISP ESCOOTER SHIPS WITH THE BATTERY PACKS DISCONNECTED
PLEASE REFER TO THE INSTRUCTIONS ON PAGE #5 TO RECONNECT THE
BATTERIES PRIOR TO YOUR FIRST CHARGING!
To charge your eScooter, first make sure the ignition key is switched to off,
then plug the output plug from the charger into the charging port.
Once connected plug the eScooter plug the charger into a standard wall
socket. The light on the charger should turn red which indicates that it is
charging and then turn green when the battery is fully charged. Remove the
charger from the wall outlet and then from the eScooter/battery as soon as
charging is complete.
8
To Next Page
Loading...
