Gio Electric WISP - Assembly Procedures; eScooter Component Checklist

Assembly
Unpack and ensure you have all of the following components. We
recommend saving all packing materials until your eScooter is fully
assembled to prevent the accidental disposal of small parts/hardware.
Please note assembly requires a Phillips Screwdriver, 4mm & 6mm Allen
wrenches and a 14mm open ended wrench.
Rear Fender
& Bracket (Not shown)
Fender Hardware
M5*12 (x2) & M5*10 (x4)
Footrest Brackets
Left (x1) & Right (x1)
Footrest Covers (x2)
Left (x1) & Right (x1)
Footrest Hardware
M6*12 (x4) & M5*10 (x4)
Footrest Plugs
Handlebar Stem Cover
Handlebar Cover
Handlebar Plug & Bolt
Pedals
Charger
Key & Fob (x2)
4