Gira System 2000 User Manual

System 2000 automatic control switch 360° pure white
Order-No. : 2270 02
System 2000 automatic control switch 360° colour aluminium
Order-No. : 2270 04
Operating instructions
1 Safety instructions
Electrical equipment may only be installed and fitted by electrically skilled persons.
Failure to observe the instructions may cause damage to the device and result in fire and
other hazards.
Danger of electric shock. Always disconnect before carrying out work on the devise or
load. At the same time, take into account all circuit breakers that supply dangerous
voltage to the device or load.
Danger of electric shock. Device is not suitable for disconnection from supply voltage.
The load is not electrically isolated from the mains even when the device is switched off.
Do not press on the sensor window. Device can be damaged.
The device is not suitable for use as a burglar alarm or other alarm.
These instructions are an integral part of the product, and must remain with the end
customer.
2 Device components
Figure 1
(1) Flush-mounted insert
(2) Motion detector cover
(3) Adjuster sens
(4) Adjuster time
(5) Adjuster lux
(6) Brightness sensor
(7) LED display, behind the lens
(8) Lens
(9) Decor ring
(10) Push-on cover
1/8
82563812 18.11.2011
System 2000 automatic control switch 360°
System 2000

Gira System 2000 Specifications

General

Operating temperature (T-T)	-20 - 45 °C
Certification	CE
Product color	Metallic
Number of contacts	3
Current	10 A
AC input voltage	230 V
AC input frequency	50 - 60 Hz

Summary

Safety Instructions

Electrical Safety Precautions

Highlights electrical safety, warning of shock hazards and advising disconnection before work.

Device Handling Warnings

Functionality and Operation

Automatic Operation Modes

Explains automatic light switching based on motion and brightness, including dimming phase with dimming inserts.

Mains Failure Behavior

Information for Skilled Persons

Fitting and Electrical Connection

Provides critical safety information and steps for fitting and electrical connection by skilled persons.

Installation Location Selection

Guides on selecting an appropriate installation location, considering detection area and environmental factors.

Motion Detector Cover Installation

Commissioning and Testing

Detection Area Testing

Guides through testing the detection area, setting the device to test mode, and observing switching behavior.

Limiting Detection Area

Setting Brightness Threshold

Setting Sensitivity

Appendix and Troubleshooting

Troubleshooting Common Issues

Provides solutions for common problems such as light not switching on or light oscillation.