GIRBAU EH080 - Page 26

Executing Programs 26
Code 429159
Rev. 15/0717
End of TILT System operation
STOP
The STOP key on the alphanumeric keyboard closes the auxiliary loading and
unloading functions screen and displays the screen for returning the washer to the
horizontal position.
Return to horizontal position.
Activate the function corresponding to the figure for tilting the washer back to the
horizontal position. Close the door. The action of closing the door also ends the
loading and unloading process.
This action does not open the drain valve. If water has been allowed in the loading
position, this water will be kept into the washer when a new cycle is started.
In the horizontal position, the STOP key opens the drainage port.