Executing Programs 29
Code 429159
Rev. 15/0717
4.14. Pausing a program as a result of a dosing unit warning
PROG. 36
PHAS. 1 2 3 4 5 6 7 8
Most dosing units that supply several washing
machines simultaneously may issue a command to
pause a washing program being run on one of the
washers connected to this unit.
The aim of this pause is to send the washing
chemicals at the right moment in each machine’s
washing cycle.
If the machine sends a dosing command while the
dosing unit is busy, the unit in turn responds to the
machine control with a command to pause the
program.
In this case, the machine will pause the program, complete the dosing signal and reach and maintain the
drum rotation, bath level and temperature values programmed in the phase.
Once the central dispensing unit cancels the pause command, the washer will continue the cycle at the
point where it paused.
The pause command is displayed on the washer display in the form of an icon in the upper left-hand
corner.
(Consult the Authorised technical service for connecting the pause signal)
ATTENTION!! This pause will only occur during the dosing time and while the dosing unit is busy. This
option is available on models with microprocessor Version 21D/21F or later.
To Next Page
Loading...
