GIRBAU EH080 - Page 60

System tools 60
Code 429159
Rev. 15/0717
PROPORTIONAL DOSING TIME
This option only appears if the PROPORTIONAL WATER LEVEL option is activated.
Modify the dosing times in proportion to the selected load.
Programmable values ............
YES / NO
Factory settings .......................
NO
EXTERNAL DOSING TIME 1
This modifies the external dosing time 1 value in seconds. This only applies to the preset programs (80-99).
Programmable values ............
0…255
Factory settings .......................
30
EXTERNAL DOSING TIME 2
This modifies the external dosing time 2 value in seconds. This only applies to the preset programs (80-99).
Programmable values ..............
0…255
Factory settings .........................
30
EXTERNAL DOSING TIME 3
This modifies the external dosing time 3 value in seconds. This only applies to the preset programs (80-99).
Programmable values ..............
0…255
Factory settings .........................
30
EXTERNAL DOSING TIME 4
This modifies the external dosing time 4 value in seconds. This only applies to the preset programs (80-99).
Programmable values ................
0…255
Factory settings ...........................
30
PURGING HOT WATER
Option that permits purging the hot water inlet piping.
Whenever the temperature programmed at the phase is equal to or greater than 50ºC, the hot water inlet
valve of the washing machine and the drain remain open simultaneously during the time specified in this
section.
Configuration only permitted in machines supplied with hot and cold water: value A2 = C in SETUP.
The multi-function and numerical keyboard can be used interchangeably.
This option can increase the water consumption of the washing machine.
Programmable values ..............
0...250 seconds
Factory settings .........................
0 seconds (NO hot water purge)
PURGE DRAIN
Configuration only allowed for machines with drain kit activated (SETUP activation) and programmed purge.
This option allows selecting the drain through which the purging water will be drained.
Programmable values ..............
Drain 1
Drain 2
Factory settings .........................
Drain 1