GIRBAU EH080 - Page 62

System tools 62
Code 429159
Rev. 15/0717
Programmable values ..............
YES / NO
Factory settings .........................
NO
PROGRAMMABLE ROTATION SPEED
Activates the programming described in section 7.3.10. that permits programming the drum rotation speed in
the wash cycle.
Programmable values ..............
YES / NO
Factory settings .........................
YES
PROGRAMMABLE HEATING GRADIENT
Activates the programming described in section 7.3.4. that permits programming distinct heating gradients.
Programmable values ..............
YES / NO
Factory settings .........................
NO
PROGRAMMABLE COOLING GRADIENT
Activates the programming described in section 7.3.13. that permits programming distinct cooling gradients.
Programmable values ..............
YES / NO
Factory settings .........................
NO
INFO A6 MODE
Activates the programming described in section 7.5, which allows the advance use of the A6(I/O2) board.
Programmable values ..............
YES / NO
Factory settings .........................
NO
PROGRAMMABLE PAUSE
Activates the programming described in section 7.3.17 that permits programming the pause in the programme
at the end of a phase. The PAUSE also activates the buzzer (beep).
Programmable values ..............
0: Programme pause not programmable.
1 - 20: programmable pause and buzzer time in seconds.
Factory settings .........................
0
SPIN TIME UNIT - SECONDS
Activates the programming described in section 7.3.16 that permits programming the spin time in seconds.
Programmable values ..............
MIN / SEC
Factory settings .........................
MIN