What to do if my GIRBAU LOGI PRO CONTROL ends with END/BAL report?
If your GIRBAU Washer displays 'END/BAL' at the end of a wash cycle, try unloading and reloading the machine. Then, restart the wash cycle, advancing the program to its last phase to repeat the spin cycle without refilling water. If the issue continues, contact the Authorised Technical Service.
Why is my GIRBAU Washer leaking water inside the cabinet?
If you notice water leaking inside the GIRBAU Washer cabinet, first, check the outlet draining pipe. Next, inspect the seals on the water inlet hoses and tighten the connection couplings. Also, examine the door seal for ruptures. If the leak persists, seal all water inlets and then contact the Authorised Technical Service.
How to fix a strange noise during spin cycle in GIRBAU Washer?
If your GIRBAU Washer is making a strange noise during the spin cycle, check the machine's levelling according to the Installation Instructions. Then, tighten the locking screws on the outside panels. If the noise continues, contact the Authorised Technical Service.
What to do if my GIRBAU LOGI PRO CONTROL door is leaking?
If the door of your GIRBAU Washer is leaking, clean the door seal to remove any deposits or linen remains.
What does ALM/HOT mean on my GIRBAU LOGI PRO CONTROL Washer?
If your GIRBAU Washer displays the error 'ALM/HOT', close the washer door to allow the cold water valve to open. Press the START/STOP key to drain the bath and access the door opening. Repeat this until the alarm disappears. If it persists after five attempts, disconnect the power supply and close the water inlet valves, then contact AUTHORISED TECHNICAL SERVICES.
Why won't my GIRBAU LOGI PRO CONTROL Washer door unlock when it says 'Hot'?
If the program is interrupted using the START/STOP key while the bath is at a high temperature, the GIRBAU Washer will automatically accept cold water and will not allow the door to unlock. When the bath temperature is below 45 ºC (133 ºF) the bath will drain and the safety door lock will be released.
What does error ALM/A-* mean on my GIRBAU LOGI PRO CONTROL?
If your GIRBAU Washer shows 'ALM/A-*', check the water entry pressure, the manual water inlet valves, and the filters in the solenoid valves. Refer to section 10: Maintenance.
What to do if my GIRBAU LOGI PRO CONTROL says 'door'?
If the GIRBAU Washer displays a 'door' error, open and close the door properly.
Lists and explains the machine's safety features, protective guards, and warning systems.
Outlines the automatic safety mechanisms integrated into the machine for user protection.
Allows personalization of programs and machine settings.
Explains how to customize wash programs and their phases.
Details how to adjust general operating parameters affecting all programs.
Explains how to customize wash programs and their phases.
Details how to adjust general operating parameters affecting all programs.
Procedure for safely releasing a person or animal trapped inside the washer.
Lists system alarms, their likely causes, and recommended procedures.
To Next Page
General
